|
[Sponsors] |
April 7, 2023, 09:39 |
ICEM Freezing when saving project
|
#1 |
New Member
Join Date: Apr 2023
Posts: 1
Rep Power: 0 |
Hello all,
I was advised to seek advice here from our University's IT services. We have an academic license for ANSYS, and it is my understanding that all university users share this license. When attempting to mesh geometries in ICEM, the software crashes at the point of saving the project. This occurs before generating the mesh, after generating the mesh- essentially, ICEM is functioning OK until the point of saving. They are completely stumped, not sure if anyone has had this problem with a shared license. I have also reached out to ANSYS support but figured it couldn't hurt to ask. We are using software version 2022 R2. Thanks, Allison |
|
April 11, 2023, 16:17 |
|
#2 |
Senior Member
Gert-Jan
Join Date: Oct 2012
Location: Europe
Posts: 1,827
Rep Power: 27 |
ICEM is no longer improved or maintained by ANSYS. Therefore I stopped installing new versions and keep on using 2020R2 which is the last one I installed.
No problems here. Could you also test older versions? It is completely fine to have multiple version next to each other. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] The ICEM Guide for CFX Users | JuPa | ANSYS Meshing & Geometry | 11 | September 4, 2017 09:43 |
OpenFOAM v3.0+ ?? | SBusch | OpenFOAM | 22 | December 26, 2016 14:24 |
[OpenFOAM.org] Compile OF 2.3 on Mac OS X .... the patch | gschaider | OpenFOAM Installation | 225 | August 25, 2015 19:43 |
Fatal Error when saving project | kurt2591 | FLUENT | 1 | January 3, 2014 04:22 |
[ICEM] Removing the Unstructured Mesh from an ICEM Project | scribby182 | ANSYS Meshing & Geometry | 2 | February 1, 2013 19:00 |