 |
 |
 |
|
|
|
[Sponsors] | ||||
May 20, 2009, 06:16
|
Meshing a Triangular part
|
#1 |
|
New Member
Waseem
Join Date: May 2009
Posts: 12
Rep Power: 16  |
Hello
I am trying to generate a structured mesh for a triangular part. The problem is that bocking I do is resulting in very complex pre-mesh. All lines tends to pass through the vertice resulting in very dense mesh near that vertice. A snap is attached also. What you suggest I should do? Waseem |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Meshing of very complicated part | Sanjay Jain | FLUENT | 9 | April 7, 2009 00:21 |
| meshing triangular channel | mu | FLUENT | 3 | February 22, 2008 11:31 |
| Please help me to meshing 3D triangular channal | rosol | FLUENT | 1 | September 7, 2007 16:52 |
| meshing hollow part of pipe | rai | FLUENT | 0 | December 19, 2005 00:46 |
| Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 11:08 |
Threaded Mode
