|
[Sponsors] |
September 25, 2009, 10:45 |
Large aspect number in GM90
|
#1 |
Member
Join Date: Mar 2009
Posts: 52
Rep Power: 17 |
Hi everyone,
I am currently scripting a geometry and mesh generation in ICEM CFD. When I create the geometry I sometimes get the following error when creating a surface: {Large aspect number in GM90}, srf.1 The surface is created from 4 curves. In my script I use the following command: ic_geo_create_surface_from_curves PART srf.1 0.001 {crv.1 crv.2 crv.3 crv.4} 1 The surface is bounded by 2 curved sides opposite of eachother and 2 straigth curves. The width is relative small compared to the length 10 w.r.t 86.5 mm. I find this error very strange since, ICEM is able to generate the surface if the width has a smaller or larger value than the current set value... The length always has the same value. Does anyone know the cause and exact meaning of this error? Thanks in advance, Regards |
|
October 12, 2009, 14:45 |
More of the script?
|
#2 |
Senior Member
Simon Pereira
Join Date: Mar 2009
Location: Ann Arbor, MI
Posts: 2,663
Blog Entries: 1
Rep Power: 47 |
Can you post more of the script so I can try it out and reproduce this error...?
Also, have you used the programmers guide under help to make sure you are using the command inputs correctly? Simon |
|
November 27, 2009, 06:58 |
|
#3 |
Member
Join Date: Mar 2009
Posts: 52
Rep Power: 17 |
Hi Simon,
Could you send me your email adres as a private message? I will send you my script and geometry files so you reproduce the error. Thank you very much for the help! Kind regards |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[mesh manipulation] Mesh Refinement | Luiz Eduardo Bittencourt Sampaio (Sampaio) | OpenFOAM Meshing & Mesh Conversion | 42 | January 8, 2017 12:55 |
DecomposePar unequal number of shared faces | maka | OpenFOAM Pre-Processing | 6 | August 12, 2010 09:01 |
[blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |
Unaligned accesses on IA64 | andre | OpenFOAM | 5 | June 23, 2008 10:37 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |