|
[Sponsors] |
[ICEM] how to create meshes of conformal nodes? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 10, 2010, 22:31 |
how to create meshes of conformal nodes?
|
#1 |
Member
stb
Join Date: Sep 2009
Posts: 39
Rep Power: 16 |
i use following methods to create meshes of conformal nodes, but fail.
1.create volume meshes in one region,then translate it into unstruct meshes 2. select respect line elements in "global mesh parameters "box 3 . create surface meshes according to this existing nodes on the common lines. and make sure the nodes color on the common lines is green. but it actually fail. who can tell me how to solve this problem? especially dear PSYMN. I look forward to your reply. thanks a lot. Last edited by snailstb; March 11, 2010 at 00:55. |
|
March 12, 2010, 02:08 |
|
#2 |
Senior Member
|
Hi, snailstb.
Did you associate the edge of block with the common lines? If don't do so, no line elements generated on the common lines, therefore, line elements won't be regarded in the process of tetra creation. |
|
March 12, 2010, 03:23 |
|
#3 | |
Member
stb
Join Date: Sep 2009
Posts: 39
Rep Power: 16 |
Quote:
|
||
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] how can i create a consistent transitions between tet and hex? specifically my model? | snailstb | ANSYS Meshing & Geometry | 3 | March 15, 2010 20:26 |
Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |