|
[Sponsors] |
[GAMBIT] problem in importing Pro Engineer geometry :-( |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Member
Arash
Join Date: Dec 2009
Location: Denmark
Posts: 37
Rep Power: 17 ![]() |
Dear all,
I am trying to use gambit in order to mesh my geometry which is a bald of wind turbine. I design that blade in ProEngineer 3 and i wanted to import this file from gambit. You can see the blade figure in attachment. The problem is gambit import only the part that created with "extrude tool", and it does not import the surfaces (which connect root to tip) ![]() it would be very very kind of you if you help me in this matter. Thanks a lot |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Senior Member
Chris
Join Date: Jul 2009
Location: Ohio, USA
Posts: 169
Rep Power: 17 ![]() |
What are you saving it as with pro-e? With solidworks, I save the part as a parasolid, and that usually works.
|
|
![]() |
![]() |
![]() |
![]() |
#4 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 ![]() |
I also import ProE (wildfire 3) within Gambit.
I choose Step file export, and I don't have any problem
__________________
In memory of my friend Hervé: CFD engineer & freerider ![]() |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem importing solidworks to gambit | holyo | ANSYS Meshing & Geometry | 3 | April 16, 2010 06:16 |
[Gmsh] Problem meshing an imported geometry | Alicia | OpenFOAM Meshing & Mesh Conversion | 0 | March 30, 2010 05:53 |
[ICEM] Problem in geometry creation by script | lavoz | ANSYS Meshing & Geometry | 4 | March 12, 2010 11:56 |
problem geometry in 2-d | thanos | FLUENT | 0 | November 24, 2009 13:22 |
Geometry setup for phase change problem | Fred G. Kang | Main CFD Forum | 1 | October 14, 1998 12:41 |