|
[Sponsors] |
July 22, 2010, 04:23 |
Pre-mesh: missing surfaces
|
#1 |
Senior Member
AB
Join Date: Sep 2009
Location: France
Posts: 323
Rep Power: 21 |
Hi,
I attached two pictures which show my issue. When the pre-mesh is created, there are missing shells. My blocking seems good, so I don't understand where it comes from. Any help is welcome Thanks, |
|
July 23, 2010, 09:33 |
Face to part
|
#2 |
Senior Member
Simon Pereira
Join Date: Mar 2009
Location: Ann Arbor, MI
Posts: 2,663
Blog Entries: 1
Rep Power: 47 |
There is probably another surface very near by, but in a different part... the premesh is reaching the one surface just before the other (it may be 0.000001 closer in some spots). There are shells there, but they are in the different part. Since you have turned that part off, they do not appear.
If it is just a duplicate part, you can probably remove it. If it is the boundary of an adjacent volume and you just want this mesh to be in a specific part without removing the other part, You can force association of those faces to the specific part... Blocking tab => Associate => Associate Face => to part. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Problems modeling CONTACT SURFACES with CFX Mesh | MAldaz | CFX | 2 | September 12, 2006 17:10 |
Points on surfaces in a rotating mesh | Martin | FLUENT | 0 | August 22, 2000 13:36 |
Mesh for 3 dim Geometry | Phil | FLUENT | 9 | July 12, 2000 04:39 |
Mesh | Mignard | FLUENT | 2 | March 22, 2000 05:12 |