|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
harry
Join Date: Sep 2010
Posts: 4
Rep Power: 16 ![]() |
hello,
i am very new to this field. i am working on centrifugal pump. i was told to to do hexahedral meshing of the pump. since it's casing, water passage and impellor are not simple geometry(i.e. with continuing changing cross section). wat can i do abt it. |
|
![]() |
![]() |
![]() |
![]() |
#2 |
New Member
harry
Join Date: Sep 2010
Posts: 4
Rep Power: 16 ![]() |
urgent plz reply
|
|
![]() |
![]() |
![]() |
![]() |
#3 |
New Member
qx
Join Date: Oct 2010
Posts: 3
Rep Power: 16 ![]() |
you may have to use ICEM. You may find that it is hard ,even impossible to use GAMBIT to do hexahedral meshing for a complicated geometry
|
|
![]() |
![]() |
![]() |
![]() |
#4 |
New Member
harry
Join Date: Sep 2010
Posts: 4
Rep Power: 16 ![]() |
||
![]() |
![]() |
![]() |
![]() |
#5 |
New Member
qx
Join Date: Oct 2010
Posts: 3
Rep Power: 16 ![]() |
||
![]() |
![]() |
![]() |
![]() |
#6 |
New Member
harry
Join Date: Sep 2010
Posts: 4
Rep Power: 16 ![]() |
i am working on centrifugal pump. the solution of the pump is not converging. the graph that is plotted during iterations shows very fluctuating lines. wat can be the problem. kindly reply.........
|
|
![]() |
![]() |
![]() |
Tags |
gambit 2.3 |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 01:27 |
Hexahedral Mesh Generation software | makotohonda | Main CFD Forum | 1 | July 14, 2010 01:04 |
[Other] Hexahedral mesh generation | makotohonda | OpenFOAM Meshing & Mesh Conversion | 0 | July 12, 2010 23:24 |
Tetrahedral and hexahedral mesh based on FVM | kuang | Main CFD Forum | 0 | July 20, 2008 05:52 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 19:10 |