|
[Sponsors] |
January 13, 2017, 05:59 |
Help Creating Surfaces In Geometry
|
#1 |
Member
sunil kumar
Join Date: May 2016
Posts: 80
Rep Power: 9 |
I am looking to make a convergent nozzle in ICEM however when i am making the surfaces i am getting a little problem I have attached a picture of what happens and was hoping someone could help
|
|
Tags |
geometry |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Creating Geometry | Fluent learner | CONVERGE | 3 | February 15, 2017 11:58 |
[Other] Creating a suction hole in a pipe geometry. | Daneish | OpenFOAM Meshing & Mesh Conversion | 2 | August 21, 2015 05:04 |
[ICEM] Issue creating geometry and trim surfaces | M4x1m | ANSYS Meshing & Geometry | 1 | February 9, 2015 08:38 |
Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam) | cfdonline2mohsen | OpenFOAM | 3 | October 21, 2013 09:28 |
[ICEM] Question about creating lateral surface for a specific geometry | lnk | ANSYS Meshing & Geometry | 2 | July 12, 2012 06:14 |