[ICEM] Can't create prism layer on 2D extruded mesh -- CFD Online Discussion Forums

February 21, 2011, 11:48	Extrude Geometry...	#4
PSYMN Senior Member Simon Pereira Join Date: Mar 2009 Location: Ann Arbor, MI Posts: 2,663 Blog Entries: 1 Rep Power: 47	You can create two points (vector) and then go to Geometry (tab) => Create Modify Surface => Sweep Surface (with a vector). This will get you the side surfaces from the curves. You can use Geometry => Transform Geometry to copy the original surfaces by the same vector. You can use the "increment parts" option if you want them to have new part names. Best regards, Simon

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to set boundary layer of a moving body in GAMBIT to a mesh zone for dynamic mesh	tomyangbath	FLUENT	18	October 12, 2016 06:57
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible	velan	OpenFOAM Meshing & Mesh Conversion	3	October 22, 2015 11:05
3D Hybrid Mesh Errors	DarrenC	ANSYS Meshing & Geometry	11	August 5, 2013 06:42
Getting prism to inflate into mixed tet-hex meshes	Joe	CFX	16	October 10, 2011 07:06
[Commercial meshers] TGridFluent mesh with internal by prism layer and internal face for diagnostic	sponiar	OpenFOAM Meshing & Mesh Conversion	2	March 30, 2009 15:02

All times are GMT -4. The time now is 11:43.