 |
 |
 |
|
|
|
[Sponsors] | ||||
March 12, 2011, 10:50
|
Airfoil
|
#1 |
|
New Member
Rohit Vasudevan
Join Date: Feb 2011
Location: Southampton
Posts: 9
Rep Power: 15  |
I have imported a 3d curve into Design Modeller... I need to create an extrusion of it... But it doesnt seem to happen.. It's only letting me extrude sketches.. Its basically an airfoil that I've imported... Is there any other way of doing it? I tried importing points as well... Even that doesnt seem to work... Any suggestions?? Thanks in advance...
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Low Speed Airfoil | Mancusi | FLUENT | 7 | April 3, 2014 06:11 |
| [GAMBIT] Meshing airfoil using .dat file problem | creggie | ANSYS Meshing & Geometry | 10 | June 27, 2010 19:24 |
| ICEM CFD Airfoil Tutorial Input | Tom | ANSYS Meshing & Geometry | 1 | September 25, 2009 06:50 |
| Modeling Backflow for a 3D Airfoil (Wing of Finite Span) | Josh | CFX | 9 | August 18, 2009 11:31 |
| Airfoil boundary condition | Frank | Main CFD Forum | 1 | April 21, 2008 18:36 |
Threaded Mode
