|
[Sponsors] |
[ANSYS Meshing] Problem with O-grid in drill pipe |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 10, 2011, 08:55 |
Problem with O-grid in drill pipe
|
#1 |
New Member
Bahadir
Join Date: Apr 2011
Posts: 5
Rep Power: 15 |
Hi guys,
I'm new in the forum and leraning CFD recently for my graduation project, so any advice would be very much appreciated. I created a drill pipe for the fluid path to be stimulated by using O-grid. However when I have a look at angles of grids from quality controls they are not so good. May be I am doing wrong with O grid ? Do some one help me? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with BC on non-overlapping grid interface | Ori Levin | FLUENT | 1 | August 29, 2006 18:32 |
Problem meshing very thin pipe | B. Hemmen | FLUENT | 2 | May 16, 2006 08:29 |
Unstructured grid problem - Laminar flow pipe | Roby | FLUENT | 0 | January 12, 2006 05:54 |
Grid Independent Solution | Chuck Leakeas | Main CFD Forum | 2 | May 26, 2000 11:18 |
nonstaggered grid problem | Zhi-Xing Yu | Main CFD Forum | 7 | August 26, 1998 13:22 |