|
[Sponsors] |
How to make appear edge/line body (created in design modeler) in the meshing tool |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 6, 2011, 04:08 |
How to make appear edge/line body (created in design modeler) in the meshing tool
|
#1 |
New Member
Rockda Kasba
Join Date: Sep 2010
Posts: 9
Rep Power: 15 |
Hi,
I would like to know how to make appear a line body in the meshing tool, after i created it in the Design modeler (2D) because for now i'm just able to see only the surface body i've created To be more clear, i will illustrate this with a very basic example. Let's say i've created a rectangular surface and i draw a line in the middle of my piece ( which will be my nozzle exit when i'll use it in fluent). After created surface body from sketch (for the rectangular surface) and line body from sketch, when i switch to the meshing tool, my line body is not appearing in the tree view and i don't know why..so i will not be able to define a velocity inlet boundary conditions later in fluent.. Hope someone will be able to answer my question,thank you very much Rockda |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Workbech design modeler geometry | Faruk | CFX | 6 | October 31, 2010 08:44 |
Installation OF1.5-dev | ttdtud | OpenFOAM Installation | 46 | May 5, 2009 02:32 |
Regarding FoamX running Kindly help out | hariya03 | OpenFOAM Pre-Processing | 0 | April 18, 2008 04:26 |
OpenFOAM with IBM AIX | matthias | OpenFOAM Installation | 20 | March 25, 2008 02:36 |
Design Modeler to ICEM..... | Joe | CFX | 0 | January 24, 2008 03:39 |