[la7low]

Hi Everyone,

could someone tell me how to create hexa prism layers (rextangular bricks) or quad elements extruded to a hexahedral elements (distorted bricks)? Ive always used blocking method before but now I must use volume/surface/prism meshing methods on a 3d geometry...

I have another question: how to create such a mesh on a 3d wing (again not using blocking) as depicted there (http://www.cfd-online.com/Forums/ans...tml#post258691) on the 4th pic?

How can you tell the prims mesher to just stop at a point without stair stepping? For me either you tell Icem prism generator to do stair stepping and you give up the boundary layer resolution (middle picture) there or you uncheck stair stepping getting crap like that on the left and right pictures.

Any help would be greatly appreciated!