|
[Sponsors] |
July 28, 2011, 10:27 |
ICEM error when I click "Split Block"
|
#1 |
Super Moderator
Philip Cardiff
Join Date: Mar 2009
Location: Dublin, Ireland
Posts: 1,089
Rep Power: 34 |
Hi,
Any time I press "Split Block" ICEM gets the error: Code:
An internal error has occurred: bad window path name "0" You can report the error to the maintainers of this software, skip the error and continue working, or view a stack trace. I have ICEM installed on a 64 bit Red Hat Linux and a 32 bit OpenSUSE Virtual Machine and both suffer from this error. This used to work for me, I think this error has started happening ever since I upgraded to v13. Any help or suggestions are welcome, Philip |
|
September 26, 2011, 06:56 |
|
#2 |
Super Moderator
Philip Cardiff
Join Date: Mar 2009
Location: Dublin, Ireland
Posts: 1,089
Rep Power: 34 |
I solved this problem by removing the ".aienv_options" file in my home directory.
Obviously some setting in it was causing the problem. Philip |
|
October 3, 2013, 16:24 |
|
#3 | |
New Member
Join Date: Jan 2011
Posts: 13
Rep Power: 15 |
Quote:
Thank you again! |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Workbench 13: Structured Hexa Meshes | rooftop | ANSYS Meshing & Geometry | 19 | March 31, 2016 02:33 |
[ICEM] complex 2D meshing on ICEM | kassab | ANSYS Meshing & Geometry | 26 | April 14, 2014 21:02 |
How to show the transient case? | H.P.LIU | Phoenics | 7 | July 13, 2010 04:31 |
Design Modeler to ICEM..... | Joe | CFX | 0 | January 24, 2008 03:39 |
ICEM CFD 5.1 Hex-Tet mesh merging failure | bogesz | CFX | 1 | January 29, 2005 06:46 |