 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] Internal Wall in Ansys Meshing |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 28, 2011, 08:56
|
Internal Wall in Ansys Meshing
|
#1 |
|
New Member
Zhang Yang
Join Date: Jun 2011
Location: Zürich
Posts: 28
Rep Power: 17  |
Hello, Guys:
I am meshing a complexe building with lots of internal wall using Ansys Meshing. Do i need to define the internal wall seperately like ICEM? thanks a lot Last edited by swiss_zhang; September 28, 2011 at 09:18. |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Fluent3DMeshToFoam | simvun | OpenFOAM Meshing & Mesh Conversion | 50 | January 19, 2020 16:33 |
| 2d meshing in ansys meshing | syler3321 | ANSYS Meshing & Geometry | 10 | November 1, 2012 21:42 |
| Velocity at wall in an internal flow | rsmartins | CFX | 3 | July 16, 2011 07:58 |
| Blow Molding meshing ansys | jdvargasd | ANSYS Meshing & Geometry | 0 | July 10, 2011 16:31 |
| Strange ANSYS Meshing 13.0 Problem | brunob | ANSYS Meshing & Geometry | 3 | June 21, 2011 21:03 |
Linear Mode
