|
[Sponsors] |
October 6, 2011, 13:42 |
gambit + number of digits + tolerances
|
#1 |
Member
kostas
Join Date: Jun 2010
Posts: 43
Rep Power: 15 |
I want to input in gambit some coordinates which have 6-7 figits after dot (0.12345678). However, the gambit operate with 5 digits. Can i change this?
Also, the number of digids of geometrical structures of NEUTRAL file can i change them? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[mesh manipulation] Mesh Refinement | Luiz Eduardo Bittencourt Sampaio (Sampaio) | OpenFOAM Meshing & Mesh Conversion | 42 | January 8, 2017 12:55 |
Gambit help: Cube inside cube | Jack Martinez | FLUENT | 13 | August 11, 2010 06:29 |
Unaligned accesses on IA64 | andre | OpenFOAM | 5 | June 23, 2008 10:37 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
meshing F1 front wing | Steve | FLUENT | 0 | April 17, 2003 12:37 |