|
[Sponsors] |
November 4, 2013, 09:31 |
building goemetry from mesh
|
#1 |
New Member
gaurav
Join Date: Nov 2013
Posts: 3
Rep Power: 12 |
hi,
i want the goemtry from a given fluent mesh file. |
|
November 5, 2013, 11:35 |
|
#2 |
Super Moderator
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Posts: 1,385
Blog Entries: 23
Rep Power: 28 |
I remember this has been discussed before for sure. I don't remember the steps but I'm sure this was discussed before, use the search tool in the forum or google . Good luck
|
|
November 13, 2013, 02:35 |
|
#3 |
Senior Member
Stuart Buckingham
Join Date: May 2010
Location: United Kingdom
Posts: 267
Rep Power: 25 |
Export surf mesh from ICEM as an STL. STLs can be read by all good CAD software (including ICEM). If you want to Premesh it in ICEM, you will have to wrap it (Octree), but you must realise that if your density is finer than the original mesh, then you are effectively oversampling the mesh, and you may get strange looking surfaces
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
[snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 09:03 |
engrid -> save as .stl with boundarie codes | Zymon | enGrid | 31 | August 29, 2011 13:40 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |