|
[Sponsors] |
[DesignModeler] Windows7, showing constraints while drawing |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 5, 2012, 12:19 |
Windows7, showing constraints while drawing
|
#1 |
New Member
Join Date: Mar 2012
Posts: 2
Rep Power: 0 |
I made a full installation of ANSYS14.0 on a 32bit windows7 Pc. When sketching in DesignModeler, the constraints are not shown (character P for point selection or C for point on axis, H or V). The check boxes for viewing constraints are set. I have the impression that it is related to some general settings of the PC outside ansys.
Is there a way around? |
|
Tags |
constraints, not visible, sketch |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Drawing Contours without showing mesh | tolu | FLUENT | 13 | May 18, 2011 16:54 |
What a Strange Drawing in GAMBIT... | teguhtf | ANSYS Meshing & Geometry | 3 | October 5, 2009 11:17 |
drawing of contour plots | chinthakindi | Main CFD Forum | 1 | April 27, 2004 04:33 |
Limit in Number of Simple Constraints | Luis Rojas-Solorzano | CFX | 6 | September 18, 2002 09:30 |
Advanced Constraints | Sudarshan Kumar | CFX | 2 | November 7, 2000 12:56 |