 |
 |
 |
|
|
|
[Sponsors] | ||||
May 2, 2012, 06:44
|
Add Mass on a rotating System
|
#1 |
|
New Member
Join Date: Mar 2012
Posts: 27
Rep Power: 15  |
Hi,
i d like to simulate a rotating Disk of a Turbine Stage. Since i just want to model the Disk itself w/o the Blades, i d like to add a mass instead with the same area moment of inertia and center of gravity as the blades. I added a small picture to illustrate the problem. I d like to add it on the "Top" Named Selection. Anyone knows if it is possible and how i could do this? |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mass flow inlet and pressure outlet with target mass flow rate | Zigainer | FLUENT | 13 | October 26, 2018 06:58 |
| Net mass flow inlet vs outlet | Nigui28 | FLUENT | 1 | August 12, 2011 11:09 |
| Mass conservation in COMSOL | Diego | COMSOL | 1 | December 27, 2010 06:14 |
| fluid mass in coupled FSI system | Dr. V. Kumar | CFX | 10 | July 16, 2007 11:23 |
| Need ideas-fuel discharge system | Jan | CFX | 1 | October 9, 2006 09:16 |
Linear Mode
