|February 5, 2013, 11:43||
porous-jump cannot be used in Eulerian multiphase flow?
Join Date: Feb 2012
Posts: 13Rep Power: 7
tested: Ansys 14.0 and 14.5
I'm setting up an internal face as porous-jump, and then when I choose the Eulerian multiphase model, it says "Warning: The porous-jump zone type is not valid with currently enabled models. Change zone type or enable appropriate models before proceeding".
If I tried to use VOF or mixture model, then it will be OK.
I'm wondering why is this incompatibility? Thanks~
|Thread||Thread Starter||Forum||Replies||Last Post|
|mesh size in Eulerian multiphase flow - liquid/solid mixture||microfin||FLUENT||4||December 23, 2016 14:55|
|Multiphase flow (Eulerian) modeling||Umesh||FLUENT||5||December 29, 2014 11:06|
|multiphase flow in porous media||zhou||FLUENT||2||August 9, 2012 07:10|
|multiphase flow in porous media||reynolds039||FLUENT||0||August 9, 2012 06:58|
|Modeling unsteady multiphase flow in porous media - convergence problem||Vaibhav Kumar||Main CFD Forum||1||July 22, 2012 04:32|