contact analysis in MFS -- CFD Online Discussion Forums

January 27, 2014, 14:59	contact analysis in MFS	#1
cynosureyoumin New Member Youmin Join Date: Jan 2014 Posts: 1 Rep Power: 0	Hi everyone, I am trying to use MFS to perform contact analysis in electrostatic simulation. You may ask why I am not using trans126 or solid226. Trans126 did not consider so much fringing effects and my tilting angle is greater than 10 deg. Since displacement is great, solid226 will also create meshing problem during pulling in. I wonder whether any of you coupled MFS with contact analysis before and would like to share the experience. Thanks!

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dynamic contact angle calculation in multiphaseInterFoam	rajeshchem	OpenFOAM	3	December 23, 2022 15:00
Dynamic contact angle	rmousavibt	Fluent UDF and Scheme Programming	12	October 31, 2021 23:38
Two way Fsi Problem- Non linear problem	kmgraju	CFX	4	April 28, 2015 12:15
help with UDF for contact angle based on contact line velocity	gandesk	Fluent UDF and Scheme Programming	14	October 29, 2012 14:58
Contact problem (boundary condition) for stress analysis	Hisham	OpenFOAM Pre-Processing	2	September 21, 2011 06:56

All times are GMT -4. The time now is 15:44.