|January 27, 2014, 14:59||
contact analysis in MFS
Join Date: Jan 2014
Posts: 1Rep Power: 0
I am trying to use MFS to perform contact analysis in electrostatic simulation.
You may ask why I am not using trans126 or solid226. Trans126 did not consider so much fringing effects and my tilting angle is greater than 10 deg. Since displacement is great, solid226 will also create meshing problem during pulling in.
I wonder whether any of you coupled MFS with contact analysis before and would like to share the experience. Thanks!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Dynamic contact angle||rmousavibt||Fluent UDF and Scheme Programming||11||January 6, 2017 16:45|
|Two way Fsi Problem- Non linear problem||kmgraju||CFX||4||April 28, 2015 11:15|
|Dynamic contact angle calculation in multiphaseInterFoam||rajeshchem||OpenFOAM||2||January 31, 2014 08:52|
|help with UDF for contact angle based on contact line velocity||gandesk||Fluent UDF and Scheme Programming||14||October 29, 2012 14:58|
|Contact problem (boundary condition) for stress analysis||Hisham||OpenFOAM Pre-Processing||2||September 21, 2011 05:56|