Home > Forums > Software User Forums > ANSYS

Volume doubles

Mark Forums Read

Reply

Search this Thread

May 14, 2014, 06:09	Volume doubles	#1
perutayam New Member perut ayam Join Date: May 2014 Posts: 1 Rep Power: 0	Hi. After comparing the volume that I calculated manually, I noticed that the volume calculated in ansys workbench (structural analysis) doubles than it supposed to be. I used creo files and it is a 2-D model. Any help is appreciated.

Reply

Tags

structural analysis

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
blockMesh error ...	balkrishna	OpenFOAM Pre-Processing	0	August 17, 2010 03:39
On the damBreak4phaseFine cases	paean	OpenFOAM Running, Solving & CFD	0	November 14, 2008 22:14
[Commercial meshers] CuBit	t42	OpenFOAM Meshing & Mesh Conversion	6	July 10, 2008 08:51
[blockMesh] Axisymmetrical mesh	Rasmus Gjesing (Gjesing)	OpenFOAM Meshing & Mesh Conversion	10	April 2, 2007 15:00
the Eulerian model and the lower volume fraction	hx li	FLUENT	2	October 27, 2005 07:17

All times are GMT -4. The time now is 08:01.