|
[Sponsors] |
October 24, 2014, 11:50 |
Ansys heat exchanger
|
#1 |
New Member
apostolis
Join Date: Oct 2014
Posts: 21
Rep Power: 12 |
Hi,
I,m new member to the cfdonline, i'm a university student and i would like to make a question. My diploma thesis is about heat exchangers and i uses Ansys. How can i make the heat exchanger recognise the pipes (or similar surfaces) as the heat exchanger surface. Sorry for my English, it' s not my native, thanks! |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Heat Exchanger Model | sak2129 | FLUENT | 3 | September 26, 2017 02:29 |
heat exchanger | sanjaypopverma | FLUENT | 1 | March 20, 2013 09:51 |
[DesignModeler] conjugate heat transfer in a heat exchanger | bhaskorb3 | ANSYS Meshing & Geometry | 0 | December 31, 2012 09:12 |
[ANSYS Meshing] meshing for dual cell heat exchanger | sandeep sethi | ANSYS Meshing & Geometry | 0 | December 29, 2012 11:19 |
Simulation flow loop of Heat exchanger | lalolala | FLUENT | 1 | November 22, 2012 00:53 |