|
[Sponsors] |
January 16, 2015, 02:28 |
Extract x,y,z coordinates from surface
|
#1 |
Member
S. Morichika
Join Date: Aug 2014
Posts: 62
Rep Power: 11 |
Hello Everyone,
Is it possible to extract x,y,z coordinates from the surface of a geometry by using ANSYS. TecPlot can extract point from poly line. Is there any option in ANSYS to extract points from the surface randomly. Thank you in advance. Saeed |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[General] extract the cell center coordinates if the CELLID is know | openfoammaofnepo | ParaView | 2 | January 12, 2017 06:54 |
[snappyHexMesh] Layers don't fully surround surface | EVBUCF | OpenFOAM Meshing & Mesh Conversion | 14 | August 20, 2012 04:31 |
Designmodeler 12 surface from coordinates | woo | ANSYS | 2 | June 20, 2011 14:06 |
CFX 4.4 New free surface option | Viatcheslav Anissimov | CFX | 0 | April 3, 2002 06:27 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |