 |
 |
 |
|
|
|
[Sponsors] | ||||
June 16, 2016, 09:59
|
Output from a Nozzle to Atmosphere
|
#1 |
|
New Member
Peter
Join Date: Jun 2016
Posts: 10
Rep Power: 11  |
Hi,
I am trying to model the output of a gas from a nozzle into the atmosphere. Would anyone have any advice on how to set up this problem? In particular how the geometry should be modeled? Any help would be greatly appreciated. I am relatively new to CFD, and using ANSYS Fluent Software. Thank you |
|
|
|
|
 |
| Tags |
| ansys, atmosphere, nozzle |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [swak4Foam] outputTime in Swak function | immortality | OpenFOAM Community Contributions | 20 | October 6, 2022 13:08 |
| Problem: Convergent- Divergent Nozzle Venting to Atmosphere | JohnPeclet | FLUENT | 2 | January 13, 2015 19:57 |
| writing execFlowFunctionObjects | immortality | OpenFOAM Post-Processing | 30 | September 15, 2013 07:16 |
| Help needed to setup CD nozzle exhausting to atmosphere | sangrampp | FLUENT | 10 | January 27, 2011 12:06 |
| compressible flow in a counterflow nozzle | d.vamsidhar | FLUENT | 0 | November 24, 2005 02:45 |
Linear Mode
