|
[Sponsors] |
How to obtain a fully-developed profile in a inlet? (ANSYS WORKBENCH) |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
victor
Join Date: Nov 2016
Posts: 2
Rep Power: 0 ![]() |
Hi everybody, I want to obtain a fully-developed profile at an inlet in one system based in 8 small pipes in counter current and Co-current inside in a bigger one. This is the geometry:
![]() I got a developed profile in a velocity value making a periodic condition in the small pipes at the outlet (I have a developed profile in the inlet). But only the velocity. I need to get a fully developed profile of temperture, heat transfer, etc as well. Any ideas? This is the developed profile of velocity at the inlet: ![]() Thank you! |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
3D pipe flow - Using UDF's to define fully developed turbulent flow on the inlet | Taz-CFD | ANSYS | 0 | February 19, 2016 07:49 |
Fully developed 3d velocity profile: Square inlet! | Taru | FLUENT | 6 | September 14, 2015 08:38 |
Fully developed inlet condition | marcoscp2 | FLUENT | 1 | May 23, 2014 07:58 |
Fully developed temperature profile for laminar/turbulent flow in FLUENT | raghu.tejaswi | FLUENT | 10 | November 7, 2012 09:57 |
Fully developed flow at inlet ? | sezenempire | FLUENT | 0 | March 27, 2012 05:37 |