The value of first cell thickness near the wall (spacing 1 ..in ICEM) ? -- CFD Online Discussion Forums

December 31, 2016, 03:50	The value of first cell thickness near the wall (spacing 1 ..in ICEM) ?	#1
rahulohlan New Member Rahul Ohlan Join Date: Dec 2016 Posts: 5 Rep Power: 9	Hello I've been trying to model the sand-water slurry flow a horizontal cylindrical pipe using the eulerian multiphase model. I'm using ICEM for meshing and all is fine, m using the spacing 1 as 0.5 mm and ratio 1 as 1.2...for refining the mesh at the wall But my solution is not getting converged even after 12000 iterations Any help what could hv been wrong ?

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Eulerin wall film model problem about film thickness	ss890527	FLUENT	1	April 18, 2017 10:29
[snappyHexMesh] snappyhexmesh cell splitted ununiform..2D case	sharonyue	OpenFOAM Meshing & Mesh Conversion	1	April 22, 2013 23:34
[ICEM] Export ICEM mesh to Gambit / Fluent	romekr	ANSYS Meshing & Geometry	1	November 26, 2011 12:11
Wall coordinates and boundary layer thickness	bentmol	Main CFD Forum	1	July 3, 2011 20:44
Warning 097-	AB	Siemens	6	November 15, 2004 04:41

All times are GMT -4. The time now is 04:25.