|
[Sponsors] |
The present data file is not allowed in blow-moulding mode polyflow |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 1, 2017, 08:11 |
The present data file is not allowed in blow-moulding mode polyflow
|
#1 |
New Member
Join Date: Jul 2017
Posts: 8
Rep Power: 8 |
Hi,
I am using ANSYS workbench blow moulding module (Polyflow) to simulate blow moulding. I can setup the part, however, when solving the model, I got this error: "The present data file is not allowed in blow-moulding mode" Can you tell me what might be wrong? I am doing everything via ANSYS workbench, I am not importing anything but the geometry. Thanks in advance, |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CFD by anderson, chp 10.... supersonic flow over flat plate | varunjain89 | Main CFD Forum | 18 | May 11, 2018 07:31 |
[OpenFOAM.org] Patches to compile OpenFOAM 2.2 on Mac OS X | gschaider | OpenFOAM Installation | 136 | October 10, 2017 17:25 |
[swak4Foam] funkySetFields compilation error | tayo | OpenFOAM Community Contributions | 39 | December 3, 2012 05:18 |
"parabolicVelocity" in OpenFoam 2.1.0 ? | sawyer86 | OpenFOAM Running, Solving & CFD | 21 | February 7, 2012 11:44 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |