|
[Sponsors] |
August 24, 2017, 03:13 |
Air Knife modelization
|
#1 |
New Member
Join Date: Aug 2017
Posts: 1
Rep Power: 0 |
Hello Everyone,
I'm new to Ansys and Fluent and I'm trying to analyse an air knife model in fluent. (Air passing trough a tiny hole in 2D) I've setup a mesh and tried to calculate the flow after the hole but my model diverge and I can't get any result. I want to calculate for a 0,5mm hole but I also tried for a 10mm just to check the model. You can find the geometry (10mm hole, 2D) enclosed. Thank you very much for your help Regards |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Air entrainment model setup for spillway | oajor | FLOW-3D | 4 | November 17, 2016 12:02 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
Simulation of air flow in a chamber | Issa | CFX | 3 | November 23, 2009 17:16 |
air bubble is disappear increasing time using vof | xujjun | CFX | 9 | June 9, 2009 07:59 |
Help!!!problems in air jet into water bath | kim | FLUENT | 4 | June 9, 2003 07:04 |