|
[Sponsors] |
3D-1D interactive coupling b/w workbench and matlab |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
YK
Join Date: Jul 2017
Posts: 8
Rep Power: 7 ![]() |
Hello forum!
I am working on a multi-scale modeling project of a pipe network. I have working 3D two way FSI model on ansys workbench and a reduced 1D model code on matlab. I am trying to set up an interface b/w models to pass output average parameters from 1D to 3D as input condition. Is there a way to link matlab and ansys for doing so? I have tried following instructions mentioned on this page http://www.ansys-blog.com/how-to-mak...pps-for-ansys/. But no luck as I couldn't get it to work. Please let me know! |
|
![]() |
![]() |
![]() |
![]() |
#2 | |
New Member
Sorin Munteanu
Join Date: Apr 2013
Posts: 26
Rep Power: 12 ![]() |
Hi,
Make sure that -aas is added in the command line of ANSYS command, or as an additional parameter if you are using the ANSYS launcher Sorin Quote:
|
||
![]() |
![]() |
![]() |
![]() |
#3 |
New Member
YK
Join Date: Jul 2017
Posts: 8
Rep Power: 7 ![]() |
Sure. Will try this Sorin. Thanks!
|
|
![]() |
![]() |
![]() |
![]() |
#4 |
New Member
Sorin Munteanu
Join Date: Apr 2013
Posts: 26
Rep Power: 12 ![]() |
||
![]() |
![]() |
![]() |
Tags |
1d reduced model, ansys workbench 16.2, coupling, matlab code, two way fsi |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Automation of parametric analysis in Workbench | shaileshbg | ANSYS Meshing & Geometry | 4 | October 16, 2017 03:49 |