|
[Sponsors] |
November 24, 2017, 05:29 |
error related to meshing
|
#1 |
New Member
Siju simon
Join Date: Nov 2017
Posts: 18
Rep Power: 8 |
I Made a model of reinforced concrete beam column joint in ansys workbench. while solving the model, after giving all force and boundary condition, it shows following two errors:
error 1: "The value of UZ at node 5073 is 6057083.95. It is greater than the current limit of 1000000" error 2: "If one or more parts of the model are held together only by contact verify that the contact surfaces are closed. Also make sure that there are constraints (or friction) in the sliding direction even if no load is applied in that direction" how can i rectify these errors |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] only automatic meshing works, | kazra | ANSYS Meshing & Geometry | 2 | February 23, 2017 11:38 |
[Gmsh] 3D coil mesh: can't create the volume? | RomainBou | OpenFOAM Meshing & Mesh Conversion | 3 | July 18, 2016 05:09 |
[Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 10:49 |
[ANSYS Meshing] Icem meshing queries | Mfaizan | ANSYS Meshing & Geometry | 21 | July 30, 2015 23:10 |