 |
 |
 |
|
|
|
[Sponsors] | ||||
May 20, 2018, 21:42
|
Porous zone and Mass Conservation issue
|
#1 |
|
New Member
Muhamad Eldebawy
Join Date: Apr 2018
Posts: 3
Rep Power: 7  |
Hi everyone,
I am modelling a closed cylinder with piston from side and porous medium from the other side. my issue is that when I set the porosity of porous zone = .5 and run the simulation for 360 degree (one revolution) .. the mass inside the system is increased during the compression stroke and decrease during the expansion until it reaches to initial state the increase is about 12% I am wondering why the mass value increases. It should be constant. By the way, if I deactivate the porous zone and run the simulation the mass still constant during the cycle. Please need your help.. thank you ----- Illustrative picture: https://www.photobox.co.uk/my/photo/...d=500789682043 |
|
|
|
|
|
May 21, 2018, 07:22
|
|
#2 |
|
New Member
Muhamad Eldebawy
Join Date: Apr 2018
Posts: 3
Rep Power: 7 |
any help guys ??
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Inconsistencies in reading .dat file during run time in new injection model | Scram_1 | OpenFOAM | 0 | March 23, 2018 23:29 |
| Fluent - Flow/heat transfer over porous media - possibly interface issue | ayihan | FLUENT | 0 | March 3, 2018 19:55 |
| Issue with begin_c_loop when more than one cell zone | Brian_ | Fluent UDF and Scheme Programming | 4 | March 2, 2018 12:44 |
| Modelling Combustion in Porous Zone | tanjinjack | FLUENT | 2 | September 26, 2016 05:10 |
| mass transfer through porous media | Ahmed Khattab | OpenFOAM Running, Solving & CFD | 1 | October 16, 2015 04:44 |
Linear Mode
