|
[Sponsors] |
Problem in Clod Flow Simulation of IC Engine in ANSYS |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 14, 2018, 05:55 |
Problem in Clod Flow Simulation of IC Engine in ANSYS
|
#1 |
New Member
Rajat Arya
Join Date: Aug 2018
Posts: 3
Rep Power: 8 |
Hey,
I am doing Cold Flow Simulation of IC Engine in ANSYS 16.2 and facing some problems regarding it. Divergence Detected in AMG Solver. Negative cell volume detected. I am doing full cycle simulation 0-720 Crank angle but after some crank angles these errors appears and solution stops. Pressure Based solver is used and K-E RNG model is used for turbulence modeling....Please give me some suggestions and Solutions so that I can analyze it properly. |
|
Tags |
cold flow simulation, ic engine |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem - simulation crashes by changing flow velocity | Harak | OpenFOAM Running, Solving & CFD | 19 | February 12, 2015 23:26 |
Propeller flow simulation in Ansys Fluent | a1ananth | FLUENT | 2 | December 4, 2014 15:30 |
ANSYS 15 CFD or Solidworks flow simulation | William_T | Main CFD Forum | 1 | October 30, 2014 03:41 |
problem in slug flow simulation | abdoganawa | Main CFD Forum | 0 | March 17, 2013 10:35 |
problem of river flow simulation | Liu | Main CFD Forum | 0 | May 27, 2004 22:01 |