Home > Forums > Software User Forums > ANSYS

ICEMCFD Number of nodes, pre-mesh plot

Mark Forums Read

Reply

Search this Thread

April 4, 2021, 05:11	ICEMCFD Number of nodes, pre-mesh plot	#1
zuheyr New Member zuheyr alsalihi Join Date: May 2018 Location: Belgium Posts: 18 Rep Power: 7	Happy Easter! Please do forgive my silly question but I am baffled: newcomer to ICEMCFD, in a simple 2D mesh with Hexa, I give 3 nodes along an edge in the bunching, and the pre-mesh plot shows me 11 grid points along that edge. Please tell me what is happening? I checked the manual: Nodesspecifies the number of nodes along the edge. The number may be modified using the up and down arrows or by entering a number in the field. I give 3 nodes, pre-mesh plots 11? Thanks for reading! Kind regards and best wishes!

Reply

Tags

hexa blocking, icemcfd, pre-mesh

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Decomposing meshes	Tobi	OpenFOAM Pre-Processing	22	February 24, 2023 09:23
Foam::error::PrintStack	almir	OpenFOAM Running, Solving & CFD	91	December 21, 2022 04:50
[solids4Foam] MultiMaterial in FSI problems	Hgholami	OpenFOAM CC Toolkits for Fluid-Structure Interaction	12	July 7, 2021 19:18
[snappyHexMesh] snappyHexMesh stuck when snap is turned on	yukuns	OpenFOAM Meshing & Mesh Conversion	3	February 2, 2021 13:05
DecomposePar unequal number of shared faces	maka	OpenFOAM Pre-Processing	6	August 12, 2010 09:01

All times are GMT -4. The time now is 10:13.