|
[Sponsors] |
February 11, 2022, 04:19 |
New iso-surface not found in reports
|
#1 |
New Member
Hazem
Join Date: Mar 2020
Posts: 11
Rep Power: 6 |
Hello guys,
I have used the mesh option in iso-surfaces to create cross-sections (airfoils) along my already solved case of a blade. The problem is I can't find those new surfaces in reports even after doing 10 more iterations. They're only visible in display (not in reports, monitors of boundary conditions) I wish you could help me find them Best Regards, Hazem. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[RapidCFD] Discussion thread on how to install and use RapidCFD | newoscar | OpenFOAM Community Contributions | 88 | May 17, 2024 09:39 |
[snappyHexMesh] Error snappyhexmesh - Multiple outside loops | avinashjagdale | OpenFOAM Meshing & Mesh Conversion | 53 | March 8, 2019 09:42 |
[Commercial meshers] converting Fluent mesh to openfoam standard mesh | deepesh | OpenFOAM Meshing & Mesh Conversion | 31 | March 29, 2017 05:59 |
Problems Installing OF 1.6 32 bit | bucksfan | OpenFOAM Installation | 19 | August 4, 2009 01:36 |
Problem of compilation OF 14Allwmake command not found | erik_d | OpenFOAM Bugs | 13 | September 13, 2008 21:45 |