 |
 |
 |
|
|
|
[Sponsors] | ||||
Parameter set output from first block as input to another |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 1, 2018, 03:56
|
Parameter set output from first block as input to another
|
#1 |
|
New Member
Jakub
Join Date: May 2018
Posts: 6
Rep Power: 8  |
Hello,
I need to do a structural analysis of an assembly for which I have already made a steady stade thermal analisys. I have created many design points in the parameters table and I would like to use all of them to the structural analysis, but I actually have no idea how to use more than just first. Is this possible? If yes please tell me how. Thank you. Cheers, Kuba |
|
|
|
|
|
May 1, 2024, 05:21
|
dublicate the block
|
#2 |
|
New Member
mahir şahin
Join Date: Oct 2022
Posts: 7
Rep Power: 3 |
as i understand from what you write, you should duplicate the analysis block in order to use same mesh structure and same setup loadings. whhen you do this, the parameters you have created previousaly will also valid for the new analysis blocks...
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using output parameter as input parameter within the same simulation | jjfm20 | FLUENT | 11 | November 6, 2017 08:53 |
| How can i assign a set of data (table or matrix) as an input for source term? | reza.s | CFX | 5 | March 2, 2015 20:31 |
| writing execFlowFunctionObjects | immortality | OpenFOAM Post-Processing | 30 | September 15, 2013 06:16 |
| [Commercial meshers] Icem Mesh to Foam | jphandrigan | OpenFOAM Meshing & Mesh Conversion | 4 | March 9, 2010 02:58 |
| How to set environment variables | kanishka | OpenFOAM Installation | 1 | September 4, 2005 10:15 |
Linear Mode
