 |
 |
 |
|
|
|
[Sponsors] | ||||
How can I start the ANSYS 12 workbench in LINUX |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 6, 2009, 22:54
|
How can I start the ANSYS 12 workbench in LINUX
|
#1 |
|
New Member
Ardisia
Join Date: Apr 2009
Posts: 2
Rep Power: 0  |
I have downloaded the linux 32bit dvd version of ansys12 from ansys customer portal
but after I installed all the files I can start fluent/cfx/icemcfd... but I cannot found the route to start workbench? Does ANSYS 12 support workbench in linux? Thanks for your reply in advance. |
|
|
|
|
|
May 7, 2009, 03:35
|
|
#2 |
|
New Member
Karl Kargl
Join Date: Mar 2009
Location: Austria
Posts: 9
Rep Power: 18 |
No, it does not. The Workbench for Linux will be released at the end of the year.
Best Regards, Karl |
|
|
|
|
|
|
May 7, 2009, 05:02
|
|
#3 |
|
New Member
Ardisia
Join Date: Apr 2009
Posts: 2
Rep Power: 0 |
Hi,Karl
Thank you |
|
|
|
|
|
|
September 7, 2010, 01:19
|
Ansys12 launch
|
#4 |
|
New Member
sugumaran
Join Date: Apr 2009
Posts: 9
Rep Power: 18 |
hi Ardisia ,,, i too facing a problem of launching Fluent12 after installation of Ansys12 package in Linux.. did u get the solution for this problem.. if so please help me.. Thanks.. |
|
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ANSYS Workbench on "Uncertified" Linux Distros | hsr | CFX | 289 | April 20, 2023 10:23 |
| [ICEM] what does the different ANSYS ICEM and ANSYS Workbench? | agungwp | ANSYS Meshing & Geometry | 8 | April 12, 2016 05:51 |
| Macro command combatibility ANSYS workbench | Tassos | CFX | 6 | January 13, 2014 05:19 |
| Ansys Workbench 10 and 11 | Rui | CFX | 1 | May 23, 2008 06:32 |
| Ansys Workbench 10.0 | Merkur | CFX | 1 | June 16, 2006 07:19 |
Linear Mode
