|
[Sponsors] |
January 3, 2011, 17:51 |
Regions in ANSYS/CFX
|
#1 |
New Member
Bobby
Join Date: Dec 2010
Posts: 21
Rep Power: 16 |
Hi
I am creating a room with a simple heated in it. I used the design modeller to create the geometry (effectively two rectangles extruded and then frozen) but when I get to the setup within CFX, my principle 3d region doesnt contain evey face? What am i doing wrong? Thanks |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
isolated fluid regions were found | alfin | CFX | 14 | October 8, 2015 02:36 |
regions, zones and sets documentation | MWilliams | OpenFOAM Programming & Development | 1 | October 14, 2011 07:44 |
Splitting regions | king_steve | STAR-CCM+ | 1 | September 27, 2010 13:48 |
Separated Regions of Centrifugal Impeller | Suzzn | CFX | 0 | February 27, 2010 12:05 |
[Other] Importing regions from 3rd party meshing programms | suitup | OpenFOAM Meshing & Mesh Conversion | 1 | November 10, 2009 10:40 |