 |
 |
 |
|
|
|
[Sponsors] | ||||
May 16, 2018, 13:33
|
Units change by creating a new design
|
#1 |
|
New Member
Reber
Join Date: May 2018
Posts: 1
Rep Power: 0  |
Hello
When i create a new design in my simulation, then change the units from mm in cm..  I can't change the units in the history with right mouse click.  Have everyone an idea? Best regards |
|
|
|
|
|
May 29, 2018, 01:20
|
|
#2 |
|
New Member
Jon Wilde
Join Date: Dec 2016
Posts: 25
Rep Power: 9 |
You should be able to change the units with a new design.
Once a model has been run though, the units are locked and can no longer be changed. Does that help? Thanks, Jon |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [DesignModeler] Creating Two Separate Bodies in Design Modeller | ashtonJ | ANSYS Meshing & Geometry | 39 | June 6, 2018 17:31 |
| How to use "translation" in solidBodyMotionFunction in OpenFOAM | rupesh_w | OpenFOAM Running, Solving & CFD | 5 | August 16, 2016 04:27 |
| How to change turbulence model in InterFoam | Gildeh | OpenFOAM Running, Solving & CFD | 4 | March 28, 2012 12:04 |
| Info: Short Course On Thermal Design of Electronic Equipment | Arnold Free | Main CFD Forum | 0 | August 10, 1999 10:18 |
| CFD - Trends and Perspectives | Jonas Larsson | Main CFD Forum | 16 | August 7, 1998 16:27 |
Linear Mode
