|
[Sponsors] |
Eulerian bubbly flow simulation with periodic boundary conditions |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 1, 2017, 00:32 |
Eulerian bubbly flow simulation with periodic boundary conditions
|
#1 |
New Member
Ali Shehryar
Join Date: Dec 2016
Posts: 13
Rep Power: 9 |
Hello Experts, Hope you are all fine.
I am trying to simulate periodic flow of an Air-Water bubbly system using Eulerian model, transient. - mesh.PNG i am using zero pressure gradient and enabled gravity to introduce the buoyancy effect. but when i run the simulation, after about 25 seconds, these (results.PNG strange vertical lines start appearing. Plus, what should be the operating density for my simulation? i have used water density as the operating density but it underpredicts the slip velocity. Kindly guide me about this too. Thank you in anticipation Last edited by Shehryar; May 1, 2017 at 00:37. Reason: typo |
|
May 6, 2017, 20:44 |
|
#2 |
New Member
|
Dear Shehryar.
Could you give me more information about this work? Thanks. |
|
May 7, 2017, 00:07 |
eulerian bubbly flow
|
#3 |
New Member
Ali Shehryar
Join Date: Dec 2016
Posts: 13
Rep Power: 9 |
thank you for concern.
yes i can share with you further information for sure. please give me your email address for further correspondence. |
|
Tags |
air-water, eulerian multiphase, periodic boundary |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CFD analaysis of Pelton turbine | amodpanthee | CFX | 31 | April 19, 2018 18:02 |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
Boundary conditions for flow in nozzle | kgevers | FLUENT | 0 | July 26, 2015 12:46 |
An error has occurred in cfx5solve: | volo87 | CFX | 5 | June 14, 2013 17:44 |
Low Mixing time Problem | Mavier | CFX | 5 | April 29, 2013 00:00 |