 |
 |
 |
|
|
|
[Sponsors] | ||||
May 17, 2023, 14:49
|
Doubt about boundaries conditions
|
#1 |
|
New Member
Join Date: May 2023
Posts: 1
Rep Power: 0  |
Hello,
I am doing a cfd simulation of oil lines to determine the pressure drop with HyperWorks. Having a non-planar fluid inlet surface (the fluid enters along a cylindrical surface, there is a valve from which the oil enters along the whole inner side area of this cylinder) how can I enter the boundary condition having a volume (or mass) flow rate? Thank you very much in advance |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fortran - Lid-Driven Cavity Boundary Conditions Error when using SIMPLE method | BaklavaBaby29 | Main CFD Forum | 8 | January 23, 2023 17:22 |
| Radiation boundary conditions for flow through boundaries in openFoam | DustExplosion | OpenFOAM | 6 | June 27, 2018 11:49 |
| Simple explain for satisfying boundary conditions in Stam and Bridson papers | AnasVFX | Main CFD Forum | 21 | June 3, 2017 13:37 |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
| Wall Heat Flux Boundaries conditions | Abigail | FLUENT | 2 | July 24, 2007 09:34 |
Linear Mode
