|
[Sponsors] |
May 18, 2012, 20:23 |
aerator simulation with CFX
|
#1 |
New Member
doumet
Join Date: Dec 2009
Posts: 9
Rep Power: 16 |
hi all...
i'm trying to solve this problem with CFX5, but till now i failed due to wrong configurations, hope you can help me with these one,and i w'll be so greatful. my problem explain how aerator works in sludge lagoon in waste water treatment plans, the aerator rotate at 43 rpm and i already made symmetry plans,but the main problem i had is what the boundary that i should add, the interfaces too, and why i can't run the problem with turbo mode? the purpose for this problem is to simulate how water get in and out throught the aerator. and to know the dead point. thanks. luai |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Proper way to name boundaries on 2D model for use in CFX? | RossFS | ANSYS Meshing & Geometry | 4 | November 10, 2011 02:38 |
Pros and Cons for CFX, CFdesign, COMSOL | Val | Main CFD Forum | 3 | June 10, 2011 02:20 |
CFX pressure in Simulations problem | nasdak | CFX | 1 | April 14, 2010 13:22 |
PhD using CFX | Rui | CFX | 9 | May 28, 2007 05:59 |
CFX 4.4 installation problem | Pandu Sattvika | CFX | 1 | December 1, 2001 04:07 |