|
[Sponsors] |
July 8, 2012, 08:06 |
Pipe
|
#1 |
New Member
Amir sadeghi pour marvi
Join Date: Dec 2011
Posts: 25
Rep Power: 14 |
hi everybody,
i study on a multiphase flow model inside tube . When water is injected into the air ، pressure drop does not change . why? mass flow rate of water:1.5---2.5 gr/s flow rate of air:66 gr/s thanks for your helps... |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[DesignModeler] DesignModeler Pipe within pipe | shields | ANSYS Meshing & Geometry | 13 | November 25, 2018 22:14 |
[ICEM] Using a hybrid mesh for a simple pipe | Udio_NT | ANSYS Meshing & Geometry | 17 | October 18, 2012 14:42 |
pipe in pipe heat exchanger | JohannV | FLUENT | 3 | December 3, 2009 02:53 |
My Revised "Time Vs Energy" Article For Review | Abhi | Main CFD Forum | 2 | July 9, 2002 09:08 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |