|
[Sponsors] |
October 11, 2012, 03:12 |
Mass flux through a particular surface
|
#1 |
Member
Prateek
Join Date: Mar 2012
Location: Bangalore
Posts: 32
Rep Power: 14 |
Hi,
I am simulating a mixing problem in which fuel and air are entering through different inlet ports. however, I am not able to get stoichiometric ratio, so, want to know how can I check the mass flux through any surface (inlet port) in CFX? If it is in .OUT file how can I check it. |
|
October 11, 2012, 05:54 |
|
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,703
Rep Power: 143 |
You can get in CFD-Post using the function calculator, or assign an expression like massflow()@inlet1 to a monitor point and then it will be available in the solver manager.
|
|
October 15, 2012, 04:49 |
mixing problem
|
#3 |
Member
Prateek
Join Date: Mar 2012
Location: Bangalore
Posts: 32
Rep Power: 14 |
Hi Glenn,
Thank u very much... I got it. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
Surface inejction- steady state - mass flow rate | CFD-student | FLUENT | 0 | January 25, 2012 13:40 |
Creating 100 derived parts / Splitting derived parts for mass flux calculation | xamo | STAR-CCM+ | 8 | September 29, 2009 05:35 |
Mass flux - Axisymmetric problems. | JSM | FLUENT | 0 | May 2, 2007 23:56 |
Mass Flux vs Velocity Inlet | Sandra | FLUENT | 5 | July 20, 2005 13:09 |