Home > Forums > Software User Forums > ANSYS > FLUENT

Mass flux - Axisymmetric problems.

Mark Forums Read

Reply

Search this Thread

May 3, 2007, 00:56	Mass flux - Axisymmetric problems.	#1
JSM Guest Posts: n/a	Hi, For axisymmetric problems how to specify the mass flux. In fluent manual, it is specified as mass flux per one radian. But i checked it by mass flow rate surface monitor at inlet, it is not taking correct mass flow rate. How to specify the mass flux for this type of simulations.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Problems with coedge curves and surfaces	tommymoose	ANSYS Meshing & Geometry	6	December 1, 2020 12:12
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 06:21
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 04:32
Creating 100 derived parts / Splitting derived parts for mass flux calculation	xamo	STAR-CCM+	8	September 29, 2009 06:35
mass flux units in kg/ms	cfd~	Main CFD Forum	0	May 3, 2007 17:45

All times are GMT -4. The time now is 17:58.