Problem with negative volume in CFX

TallesC · February 4, 2013, 09:59

uys, I'm trying to run a case in cfx, but the next problem was reported:

* ERROR # 002100012 has occurred in subroutine cVolSec. |
* | Message: |
* | A negative ELEMENT volume Has Been detected. This is a fatal |
* | Error and execution will be terminated. The location of the first |
* | Reported negative volume is below. |
* | Volume:-0.1504E-09 |
* | Location: (0.17198E +02,-0.96809E +00, +01 0.16941E)

how can I solve this problem??

ghorrocks · February 4, 2013, 16:26

http://www.cfd-online.com/Wiki/Ansys..._went_wrong.3F

February 4, 2013, 09:59	Problem with negative volume in CFX	#1
TallesC Senior Member Talles Caio Join Date: Oct 2012 Location: Brazil Posts: 101 Rep Power: 13	uys, I'm trying to run a case in cfx, but the next problem was reported: * ERROR # 002100012 has occurred in subroutine cVolSec. \| * \| Message: \| * \| A negative ELEMENT volume Has Been detected. This is a fatal \| * \| Error and execution will be terminated. The location of the first \| * \| Reported negative volume is below. \| * \| Volume:-0.1504E-09 \| * \| Location: (0.17198E +02,-0.96809E +00, +01 0.16941E) how can I solve this problem??

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Negative Volume during Mesh Motion Analysis	giov_ingr	FLUENT	2	December 13, 2013 06:09
Negative cell volume problem in-cylinder	ziani.lotfi	FLUENT	0	April 11, 2012 07:54
[blockMesh] error message with modeling a cube with a hold at the center	hsingtzu	OpenFOAM Meshing & Mesh Conversion	2	March 14, 2012 09:56
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55
Negative element volume & folded mesh in cfx 11.0	siavash ghassemi	CFX	2	December 28, 2007 13:17

February 4, 2013, 16:26		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,703 Rep Power: 143	http://www.cfd-online.com/Wiki/Ansys..._went_wrong.3F