|
[Sponsors] |
April 17, 2013, 09:00 |
Creating polyline from surface intersection
|
#1 |
Member
Rolando Figueiredo
Join Date: Mar 2013
Posts: 41
Rep Power: 13 |
Hello!
Now that I am trying to post-process some results I can't figure out how to create polylines that are not on boundaries (unless you use a csv file). Does anyone have a clue on how to create polylines by intersecting an interface boundary and a surface of revolution? ANoher question would be how to control the chart count? Apparently the default is 50 points, but sometimes I get 70... Here's a pic to illustrate. Basically I want to mid-section the annulus! Untitled.jpg Thanks! |
|
April 17, 2013, 21:36 |
|
#2 | |
Senior Member
Join Date: Dec 2009
Posts: 131
Rep Power: 19 |
you will most likely get more information and flexibility using the Turbo tab in CFD-Post.
Quote:
|
||
April 18, 2013, 05:54 |
|
#3 |
Member
Rolando Figueiredo
Join Date: Mar 2013
Posts: 41
Rep Power: 13 |
Yeah, that helps a lot!
Cheers! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Comsol (4.3): convert parametric surface into block? | sgalaz | COMSOL | 0 | November 9, 2012 09:20 |
killed "snappyHexMesh" | parkh32 | OpenFOAM Pre-Processing | 2 | April 8, 2012 17:12 |
How can I define a intersection surface with ICEM? | BEN EZZEDDINE Anouar | CFX | 0 | November 15, 2005 06:05 |
creating volume from a surface file for CFD | Amir | Main CFD Forum | 0 | December 24, 2002 02:08 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |