|
[Sponsors] |
June 3, 2013, 21:27 |
Velocity different than Expected
|
#1 |
New Member
AJ Hunter
Join Date: Feb 2013
Posts: 29
Rep Power: 13 |
I have just ran a fluid model with a given mass flow rate for water. I did hand calculations and determined that my velocity at a particular point of the setup should be about 57 ft/s. However, CFX gives me a velocity of 107.88 ft/s. Does anyone know why this might happen.
ABOUT THE MODEL: A single pipe comes in and then splits into 25 smaller channels, which then go back into a single pipe of different diameter. The channels are the locations where I calculated the expected velocity. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Plotting Radial Velocity and Tangential Velocity in CFD Post | ashtonJ | CFX | 5 | July 13, 2015 02:49 |
Compiling OpenFOAM13 on AMD64 with OpenSUSE 101 | silent_missile | OpenFOAM Installation | 5 | August 10, 2007 07:31 |
Velocity in Porous medium : HELP! HELP! HELP! | Kali Sanjay | Phoenics | 0 | November 6, 2006 06:10 |
Neumann pressure BC and velocity field | Antech | Main CFD Forum | 0 | April 25, 2006 02:15 |
what the result is negatif pressure at inlet | chong chee nan | FLUENT | 0 | December 29, 2001 05:13 |