|
[Sponsors] |
September 25, 2013, 04:58 |
Simulation in CFX about CRF
|
#1 |
New Member
Ch
Join Date: Nov 2012
Posts: 5
Rep Power: 13 |
Dear friends,
I have a very robust design of a contra-rotating fan, now I need to validate this design and find the problems. However, after i generated the mesh in turbogrid and set up all the parameters in pre-CFX, I always got the problem "floating point exception: overflow". I did a lot of changes, such as improving the mesh, adding the good initial conditions, decreasing the timestep and changing the turbulence model to SST. However, I still can not get proper convergent results. Can anybody help me to check the case? Here I can not attach the .def and .cfx files since it is too large. If there is sombody who can help me, I will send you those files by email. Thanks very much! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Blast simulation with ANSYS CFX or FLOW-3D etc. | xji | ANSYS | 0 | November 30, 2012 16:57 |
CFX vs FLUENT for particle tracking simulation | iman | ANSYS | 2 | August 31, 2012 20:34 |
nucleate boiling simulation in CFX | Anil | CFX | 3 | August 25, 2010 14:18 |
2D simulation - ICEM meshing for CFX question | Ben Makhal | CFX | 5 | April 11, 2007 08:44 |
Simulation of turbine cascade in CFX. | Jonas Pedro Caumo | CFX | 0 | December 9, 2006 13:54 |